Manual
Appendix F: Cabinet Separation
Cabinet Separation for Model WS-65311
Instructions for Separating the Upper and Lower
Section of the Projection Television Cabinet
For Mitsubishi Dealers and Service Personnel ONLY
This Mitsubishi projection television cabinet has been assembled in two pieces.
These pieces may be separated to allow for easier delivery and setup.
The instructions below show how to safely separate and reattach the cabinet.
@This projection television weighs over 320 pounds and has many sensitive components.
_This dismantling procedure should be done by authorized Mitsubishi Dealers or Service
Personnel ONLY.
The following operations should be performed by two
people:
Front Cabinet Disassembly Procedures
O Remove the Speaker Grille by gently pulling both the right
and left side of the Speaker Grille away from the wood cabinet.
_]_ Undo the wire ties and disconnect the CC and ZF connectors.
Remove the Screws that attach the Screen Frame to the wood
Cabinet-Bottom. The Screws are located at the bottom portion
of the screen frame.
O This operation should be performed by two people. Carefully
remove the Screen Frame by holding the sides and bottom
of the frame and lift the frame vertically off the Cabinet.
NEVER PULL THE SCREEN FRAME FROM THE TOP.
O Place the Screen Frame in a location where nothing will come in
contact with the screens. The screens' surface can be damaged if
not properly handled.
J
f
Speaker Grille
Hold Speaker
Grille here
Cabinet Separation Procedure
Remove the decorative Plastic Covers (2) on each side
of the cabinet and then remove the exposed
Screws (2) on each side.
_) Carefully lift the Cabinet-Top vertically until the Brackets are
clear from the Cabinet-Bottom.
O Carefully place the Cabinet-Top on the floor.
Brackets
Plastic Covers,
Screws
Cabinet-Top
0
Cabinet Re-assembly
Once you have moved and positioned the Cabinet-Bottom
to itsdesired location, reverse the procedure and mount
the Cabinet-Top on the Cabinet-Bottom. Be sure you align
the Brackets properly. KEEP FINGERS CLEAR OF ALL JOINTS!
Replace the Screws and the decortive Plastic Covers that were
removed in step_. Reinstall the ScreenFrame _]). Replace the
Screws per stepO. Place wires in the wire ties and join the connectors
per step _D. Reinstall Speaker Grille O.
O