Operation Manual

EN-14
Setting up your projector (continued)
Adjustment using the KEYSTONE mode:
When the screen and the projector are not placed
perpendicularly to each other, projected images
become trapezoidal. If you cannot place them
perpendicularly to each other, press the ENTER/
GEOMETRY button on the projector or the
GEOMETRY button on the remote control to display
the KEYSTONE mode and then press the , ,  or
 button to correct the distortion.
KEYSTONE
KEYSTONE
SELECT : BLANK
: 0
: 0
Every time you press the BLANK button, the
adjustment menu changes as follows:
KEYSTONE → RESET → KEYSTONE ...
KEYSTONE menu
You can correct the distortion vertically or horizontally
focusing on the screen center.
In the following cases (for front projection):
Press the

button.
Press the

button.
Press the

button.
Press the

button.
When you press the  or  button in the RESET
mode, the distortion correction is reset.
Important:
• Thebestadjustmentresultcanbeobtainedwhen
the lens is positioned at the center of the lateral
direction at the top in the longitudinal direction
(when the projector is installed on the floor, or
at the bottom when it is installed on the ceiling).
Before performing the keystone adjustment, reset
the lens position to the default position by using
LENS SHIFT RESET (see page 33) and then move it
to the top using LENS SHIFT (see page 12).
• WhentheKEYSTONE-modeadjustmentiscarried
out, the adjustment value is indicated. Note that
this value doesn’t mean a projection angle.
• WhentheKEYSTONE-modeadjustmenttakes
effect, the resolution decreases. In addition, stripes
may appear or straight lines may bend in images
with complicated patterns. They are not due to
product malfunctions.
• WhentheKEYSTONE-modeadjustmentis
performed, the displayed image may be distorted.
• Dependingontheinstallationconditionsofthe
projector and the screen, a perfect rectangular
image and the proper aspect ratio may not be
obtained. Slight distortion can be corrected by the
CORNERSTONE-mode adjustment.
• Noisemayappearonthescreenduringthe
KEYSTONE-mode adjustment because of the type
of the video signal being projected and the setting
values of the KEYSTONE-mode adjustment. In
such cases, set the KEYSTONE-mode adjustment
values in the range where the image is displayed
without noise.
• WhenyoucarryouttheKEYSTONE-mode
adjustment and the CURVED-mode adjustment
in combination, the adjustment range becomes
narrower than that in the case where you carry out
these adjustments individually. When setting the
KEYSTONE-mode adjustment value to 11 or larger,
you cannot use the CURVED-mode adjustment.
• WhencarryingouttheKEYSTONE-mode
adjustment while the option lens is in use, you
may not be able to obtain a perfectly rectangular
image or the correct aspect ratio. Slight distortion
can be corrected by the CORNERSTONE-mode
adjustment.
Adjustment using the CORNERSTONE mode:
Use this adjustment for fine adjustment of the image
shape. For adjustment, press the ENTER/GEOMETRY
button on the projector or the GEOMETRY button on
the remote control to display the CORNERSTONE
mode and then press the , ,  or  button.
CORNERSTONE
LOWER RIGHT
SELECT : BLANK
: 0
: 0
Every time you press the BLANK button, the
adjustment menu changes as follows:
LOWER RIGHT → LOWER LEFT → UPPER RIGHT →
UPPER LEFT → RESET → LOWER RIGHT ...