Extra Information

EN-10
4. Projector registration
4.2. Registration of projector to “ProjectorView Global+”
Theprocedurestoregisterprojectorsvaryamongtheforegoingconnectionexamples.
• Inconnectionexamples1and2(whereprojectorsareinstalledwithinthesamelocalnetwork),theprojectors
within such network are automatically detected and registered. For details, see procedure A below.
• Inconnectionexample3(whereprojectorsareinstalledviaarouter),specifytherangeoftheprojectors’IP
addresses and then carry out automatic projector search within the range to register projectors. For details,
see procedure B below.
• Upto200unitsofprojectorscanberegisteredatthemaximum.
• Projectorsthathavejustbeenregisteredbytheautomaticprojectorsearcharen’tbelongingtoanygroup.
When the projectors you registered aren’t displayed on the projector list on the main screen, select “All” from
the group select pull-down menu.
Procedure A - For connection examples 1 and 2 (where projectors are installed within the
same local network)
(1) Start up “ProjectorView Global+”.
(2) Select “Search Projector” from “Configuration” of the menu bar on the main screen.
• TheprojectorsconnectedtoLANaresearchedautomatically.
• Someprojectorsmayrequireyoutoenterthepasswordwhenestablishingprojectorconnectionsfortherst
time. If the projector password is changed, you need to enter that new password.
<Note>
• EnsurethattheIPaddressofthePCandthatoftheprojectorareinthesamenetworkgroup.(Thelastoctet
of the IP address should contain a different value.)
• BesuretomakeanoteoftheIPaddressesyouset.IfyouforgettheIPaddresses,youmaynotbeableto
detect the projectors again.
• Atinitialsetup,DHCPorAutoIP(169.254.0.1through169.254.255.254)automaticallyassignsanIPaddress.
Note that a different IP address may be assigned every time you start the projectors. If a connection cannot
beestablished,execute“SearchProjector”.
• IfyouchangetheIPaddressintheprojectormenuaftertheprojectorshavebeendetected,execute“Search
Projector” again.
• ItisrecommendedthatyouassignanIPaddressoftheprojectortothexedIPaddress.
• IfseveralprojectorswiththesameIPaddressareregistered,deletetheoneswhicharenotconnectedtothe
network from “Edit Projector Setting”.