Extra Information

EN-26
8. ProjectorView
8.6.2. E-mail setting
(1) Click [SETUP] button in the ProjectorView main window (ALERT E-MAIL).
• AlertE-mailSetupwindowisdisplayed.
<Note>
• BesuretoenterdatawithinveminutesaftertheAlertE-mailSetupwindowisdisplayed.ClickOKtosave
changes. The connection will turn off in five minutes after the window is displayed so you need to go back
to the main window (ALERT E-MAIL) to access the Alert E-mail Setup window.
(2) Set each item referring to the explanation described below.
Thefollowingtableexplainseachitem.
Regarding the settings, consult your network administrator or check the settings of your E-mail server.
Item Description
Alerte-mailservice TurnON/OFFthesendingofanalertE-mail.
SMTP Server *
1
Enter the name of the SMTP server that is used for sending an E-mail. (Designate by
URL or IP address.)
Port *
2
Enter the port number of the SMTP server. (Default value: 25)
DNS Server *
3
Enter the name of the DNS server when you designate the SMTP server or POP
server using an URL. (Designate by IP address.) For details, consult your network
administrator.
E-mailaddress1/2/3*
4
 EnterthedestinationaddressofthealertE-mail.(e.g.[e-mail])
(Up to 64 characters) (Up to 3 addresses can be designated.)
E-mail from *
4
 EnterthesourceaddressofthealertE-mail.(e.g.[e-mail])
Authentication settings Configure the following settings when you use the SMTP server having the
authentication function.
Authentication method Select the authentication method for sending an E-mail.
OFF: No authentication for sending an E-mail.
SMTP-Auth: To use this method, enter User name, Password, and SMTP-
Auth method.
POP before SMTP: To use this method, enter User name, Password, POP Server
name, and Port number.
User name *
4
(When you select the SMTP authentication) Enter the user name and password
registered on the SMTP server.
Password *
4
(When you select the POP before SMTP) Enter the user name and password
registered on the POP server.
SMTP-Auth method Select the SMTP authentication method.
Plain: Password is sent to the SMTP server unencrypted.
Login: Password is sent to the SMTP server unencrypted.
CRAM-MD5: Password is sent encrypted.
POP server *
1
Enter the POP server name that is used for the POP before SMTP authentication.
(Designate by URL or IP address.)
Port *
2
Enter the port number of the POP server. (Default: 110)
*
1
Use only alphanumeric characters and marks (- _ . ˜).
*
2
For data entry, use alphanumeric characters.
*
3
For data entry, use alphanumeric characters and mark (.).
*
4
 Fordataentry,usealphanumericcharactersandmarks(+-/=*_!?.,:;#$%&()|<>[]{}"' @).