Extra Information

EN-30
9. Visual PA2 (Visual PA2 enabled projectors only)
9.5. Configuring the Schedule function of Visual PA2
By using the Visual PA2’s Schedule function, your intended messages can be displayed on the screen at a set
time.
(1) Click [Edit] in the Schedule area.
• "VisualPA2Schedule"windowisdisplayed.(Thewindowbelowshowstheexamplewhentheschedules
have been entered in three rows.)
    


Item Description
 Enable Enables the Schedule function for a particular day or period in each row.
 Day From the pull-down menu, selects the day or period during which the Schedule
functionisenabled.(YoucanselectyourchoicefromSun,Mon,Tue,Wed,Thu,
Fri, Sat, Mon-Fri, Mon-Sat, Sat-Sun, and Everyday.)
 Turn-on Time From the pull-down menu, sets the start time in the Schedule function.
 Period From the pull-down menu, sets time period during which a message is displayed.
 Data Name From the pull-down menu, selects the message to be displayed on the screen
when the Schedule function is enabled.
(More than one message should be saved in advance. See “9.2. Saving
messages entered and settings specified in Visual PA2” on page 29.)
 Clear Clears all entries from the selected row.
 Exit Saveschangesandclosesthewindow.
(2) Configure settings ( through ) and check/uncheck the checkboxes for .
• Uptotenschedulescanbecongured,usingthefourrowsinthetable.(Youcancongureaschedulefor
each row.)
• Bydefault,whennoscheduleisentered,thetablehasonlyonerow.Anewrowisautomatically
added when you enter the items for , , , and  in the first row. In this manner, up to ten rows are
automatically added to the table.
(3) Click [Exit] to close the window.
<Note>
• Onceaschedulehasbeencongured,itisexecutedautomaticallyeveniftheVisualPA2windowisnot
displayed.
• IfyousendmessagesmanuallyfromVisualPA2whenascheduleisbeingexecuted,thesemessageshave
higherpriorityoverthatschedule.Inaddition,whenthesettingsofaschedulecurrentlybeingexecutedare
reconfigered, the Visual PA2 window will close automatically.
• Morethanoneschedulecannotbeconguredatthesametimeonthesameday.
• TheScheduleSettingwillbeexecutedwhile“ProjectorViewGlobal+”isinoperation.
• Dependingonusageconditions,suchaswhentherearesomanyprojectorstocontrol,timelapsesmayoccur
between the start time of Visual PA2 and the start time of a schedule.
• WhenNetworkTimeProtocol(NTP)isusedtoautomaticallysynchronizewithanInternettimeserver,thestart
time of a pre-configured schedule may not match the clock of the projector, and the schedule may not be
executed.
• Whentheautomatictimeadjustmentbysummertimeisvalid,thescheduleoperationmaynotbeexecuted
because the time is automatically adjusted before and after switching over.