Operation Manual

EN-19
1
Viewing computer images (continued)
1. Plug the attached power cord into the power cord inlet of
this projector.
2. Plug the other end of the power cord into a power outlet.
t 0OFPGQPXFSDPSETGPSUIF64&VSPQF6,"VTUSBMJBBOE4PVUI,PSFBJTQSPWJEFEBQQSPQSJBUFMZ
t 5IJTQSPKFDUPSVTFTUIFQPXFSQMVHPGQJOHSPVOEJOHUZQF%POPUUBLFBXBZUIFHSPVOEJOHQJOGSPNUIFQPXFS
plug. If the power plug doesn’t fit your wall outlet, ask an electrician to change the wall outlet.
t *ODBTFUIBUUIFQPXFSDPSEGPSUIF64JTQSPWJEFEXJUIUIJTQSPKFDUPSOFWFSDPOOFDUUIJTDPSEUPBOZPVUMFU
or power supply using other voltages or frequencies than rated. If you want to use a power supply using other
voltage than rated, prepare an appropriate power cord separately.
t Use 100-240 V AC 50/60 Hz to prevent fire or electric shock.
t Do not place any objects on the power cord or do not place the projector near heat sources to prevent damage to
the power cord. If the power cord should be damaged, contact your dealer for replacement because it may cause
fire or electric shock.
t Do not modify or alter the power cord. If the power cord is modified or altered, it may cause fire or electric shock.
2
1
Power cord (example)
About DDC
The COMPUTER/COMPONENT/VIDEO IN 1 terminal of this projector complies with the DDC1/2B standard and the
COMPUTER/COMPONENT/VIDEO
DVI-D IN (HDCP) terminal complies with the DDC2B standard. When a computer
supporting this standard is connected to this terminal, the computer will automatically load the information from this
projector and prepare for output of appropriate images.
t "GUFSDPOOFDUJOHBDPNQVUFSTVQQPSUJOHUIJTTUBOEBSEUPUIJTUFSNJOBMQMVHUIFQPXFSDPSEPGUIFQSPKFDUPSJOUIF
wall outlet first, and then boot up the computer.
Earthing
terminal
B. Plugging the power cord
t *OPSEFSUPFOTVSFUIFTBGFUZJODBTFPGUSPVCMFXJUIUIFQSPKFDUPSVTFBOFMFDUSJDBMPVUMFUIBWJOHBOFBSUIMFBLBHF
breaker to supply the power to the projector. If you do not have such outlet, ask your dealer to install it.
Monitor
For monitor connection:
1. Connect the computer cable from the monitor to the
MONITOR OUT terminal of the projector.
t 0OMZXIFO45"/%#:.0%&JTTFUUP45"/%"3%WJEFP
signal is output from the MONITOR OUT terminal during
power standby.
For audio output connection:
1. Connect one end of a commercially available audio cable
to the AUDIO OUT terminal of the projector.
2. Connect the other end (white and red) of the audio cable to
the audio input terminals (L, R) of the audio equipment.
t 8IFOUIFBVEJPDBCMFJTDPOOFDUFEUPUIF"6%*0065
terminal, the speaker output is muted.
Audio cable (option)
To audio input
terminals
MONITOR OUT
Computer cable
2
1
AUDIO OUT