User Manual Part 3

Mitsumi Electric Co., Ltd. Wavit11 User's Manual
107/108
CONFIDENTIAL
Are the encryption keys
appropriately set?
You need to set same
encryption keys. Open the
configuration tool, and write
in encryption keys again.
Is the channel set appropriately? In Wireless Bridge mode, you
need to set the same channel.
Open the configuration tool,
and confirm the channel.
Was the MAC address properly
set?
You need to set the target
MAC address correctly. Open
the configuration tool, and
confirm the MAC address.
It does not communicate in
Wireless Bridge mode.
Are the encryption keys
appropriately set?
You need to set the same
encryption keys. Open the
configuration tool, and write
in encryption keys again.
Was the network configuration
of Personal computer set
properly?
Refer to Operating System
User’s Manual.
Does it communicate properly
when personal computers are
connected to each other with
10BASE-T cross cable?
Refer to the Operating System
User’s manual and configure
the networks.
It does not communicate in all
modes.
Can Wavit11s make
communication when they are
installed in the neighborhood?
The distance is too far.
Change the Wavit11 position
to enable the communication.
The configuration tool does not
start.
What is your operating system? For configuration tool, you
need Windows95+IE4.01 or
above.
Can you find Wavit11s on the
screen in the top window of
configuration tool?
Connect personal computer
and Wavit11 using 10BASE-T
straight cable.
Is the TCP/IP protocol installed
to your personal computer?
Refer to User’s manual of the
personal computer to install
the TCP/IP protocol to your
personal computer.
Setting is not feasible with the
configuration tool.
Is the network address of
Wavit11 IP address the same
with that of the personal
computer?
Open the configuration tool,
and change the IP address so
as to match the network
address.
Was the unusable IP address
set?
Open the configuration tool
and perform initialization.
After initialization, you need
to set up all configurations
again.
I have forgotten the password. Open the configuration tool
and perform the initialization.
After initialization, you need
to set up all configurations
again.