user manual

6 - 25 No. 99MBC095A
6. INTERFACE UNIT
2) Data output
a. When a data send request comes from the external equipment such as the Digimatic Data
Processor to the LSM, the measurement data will be outputted through this interface by
the following timing.
• When the
DATA
key on the Digimatic Data Processor is pressed
• When the foot switch being connected to the Digimatic Data Processor is pressed.
• When an REQ signal is inputted from other external equipment.
b. When the measurement is initiated by pressing the
RUN
key, or by receiving a RUN
input from the I/O interface or “R” command from the RS-232C/GP-IB interface, the
measurement data will be outputted according to the data output conditions being set.
6.2.1.2 Name of each part
DIGIMATIC CODEOUT
OUTPUT-1 OUTPUT-2
9
10
1
2
9
10
1
2
Connector
Digimatic Output Unit 1 connector Digimatic Output Unit 2 connector
fognitsisnoCytitnauQ
tinutuptuOcitamigiD1
elbacgnitcennoC1