user manual

6 - 40 No. 99MBC095A
6.2.3 BCD interface
This interface outputs data in parallel format. The output data consists of a positive true
logic/negative true logic signal and a decimal number (BCD)/Hexadecimal number (HEX).
6.2.3.1 Method of use
1) Installation and setup of the interface
• By referring to Section 6.2.3.3 “Specification”, set the jumper switches and DIP switches
to meet the purpose of measurement.
• Install this interface unit in the Display Unit. For the installation method, refer to Section
6.3 “Installing the Optional Interface Unit”.
6.2.3.2 Name of each part
18
36 19
1
BCD I/F
1JP3
1
1
JP2
SW1
JP1
1
Connector
BCD interface connector
Connector 1 pin mark ( )
Jumper switch: JP1
Jumper switch: JP2
DIP switch: SW1
Jumper switch: JP3
fognitsisnoCytitnauQ
ecafretniDCB1
)06303-75(rotcennoC1
elbacgnitcennoC1