user manual
3 - 6
No. 99MBC032A
3.1.2.1 Basic setup mode
• This mode is used to customize the basic setup conditions, including the resolution,
interface conditions, and available functions, according to the measurement requirements.
For more information, refer to Section 4.1, “Basic Setup”.
• To enter the basic setup mode turn on the power (turn the key switch clockwise from the
“O” position to the “I” position) while holding down the
SET
key. Hold down the
SET
key for about 2 seconds to initiate the basic setup mode.
3.1.2.2 Calibration mode
• Depending on the environment in which the LSM is used, measurement errors may result.
Therefore, always perform calibration prior to use, taking the measuring range and
environmental conditions into account.
If calibration is performed, the errors described above will be reduced and high accuracy
will be ensured.
• Before performing calibration, always make the setups for resolution, simultaneous
measurement and available segments in the basic setup mode. If this order is reverse, the
previously set calibration values may be discarded.
• For more information, refer to Section 4.2, “Calibration”.
• Press the
H.CAL
key to enter the HI CAL mode; and press the
L.CAL
key to enter the LOW
CAL mode.
3.1.2.3 Measuring condition setup mode
• This mode is used to set up measuring conditions, including segments (objective portion of
workpiece to be measured) and GO/NG judgment criteria.
• Press the
SET
key to enable all the function setup items established to be set in a batch.
• Each of the
LIMIT
,
SHIFT
,
MASTER
/
OFFSET
, and
REF
keys allows the individual function
setup item to be established.
• Press the key to enter the setup operation for the setup item which is used most
often.
3.1.2.4 Other setup mode
• This mode is used to set the key lock and to set the unit of measurement.
• Press the
SHIFT
and
LOCK
/
UNIT
key to turn on and off the key lock; and press only the
LOCK
/
UNIT
key to enter the unit change mode.
• Press the
SHIFT
and
READ
key to enter the measuring position display mode.
3.1.2.5 Statistic display mode
• Displays the statistical processing results.
• Press the
SHIFT
and
STAT
/
S.E
keys in the ready state to enter the statistic display mode.
• Press the
SHIFT
and
S.PR
/
PRINT
keys in the ready state to allow the statistical processing
results to be printed.