user manual

3. BASIC OPERATIONS
Step 4 While the “n” at the left end of the display is blinking, enter the number of
divisions using the ten-key and press the Load key. If an auto-recalled value is
used, only press the Load key. The KA counter display becomes ready for input
of the offset angle.
Step 5 While the “Ang” at the left end of the display is blinking, enter the offset angle
using the ten-key and press the Load key. If an auto-recalled value is used, only
press the Load key. After this value is entered, the setting complete code (000)
followed by the number of divisions is displayed for two seconds.
Step 6 Press the Load key and call up the first target value, and execute the bolt-hole
circle machining at the specified location.
No. 99MBE032A
3-19