user manual

4. PARAMETERS
Parameter
No.
Parameter Function Setup Data Initial Value
95 • Digit shift
Used to adjust the display value in combination
with Parameters 92, 93, and 94.
0: 1
1: 1/2
2: 1/5
3: 1/10
0 (1)
96 Over-speed frequency 0: 50kHz
1: 100kHz
2: 150kHz
3: 200kHz
4: 250kHz
5: 300kHz
1 (100kHz)
97 AOS communication error detection times 0: 10
1: 5
2: 1
0 (10)
98 AT700 series power calibration 0: Not perform
1: Perform
0 (Not
perform)
99 Refresh frequency of counter 0: 70mS
1: 30mS
2: 10mS
0 (70mS)
IMPORTANT
Even when the counting mode is restored by operating the Cancel key after the
parameter setup mode has been entered with the AT100-series scale being connected,
the display will only show 0.000 irrespective of the setup values of Parameters 15 and
17 without the display value, existed when the power was last turned off, being restored.
No. 99MBE032A
4-9