Manual

ManualsBrandsMitxPC ManualsCarVoomPC

VoomPC™ Automotive PC Enclosure

Mini-ITX Car PC Enclosure

Installation Guide

Version 1.1

P/N VOOM-01

Before you start…

Please take a moment and read this manual before you install the VoomPC™ in your

vehicle. Often times, rushing into unit installation can result in serious damage

your motherboard, power supply and probably your car’s electrical system.

The VoomPC has a wire harness that need to be connected to the car’s electrical

system. During installation, always double check the polarity of your wires with a

voltmeter.

Summary of content (4 pages)

PAGE 1
VoomPC™ Automotive PC Enclosure Mini-ITX Car PC Enclosure Installation Guide Version 1.1 P/N VOOM-01 Before you start… Please take a moment and read this manual before you install the VoomPC™ in your vehicle. Often times, rushing into unit installation can result in serious damage to your motherboard, power supply and probably your car’s electrical system. The VoomPC has a wire harness that need to be connected to the car’s electrical system.
PAGE 2
1.0 Introduction Thank you for purchasing the VoomPC mini-ITX vehicle enclosure. The VoomPC was designed to work with a wide variety of main boards such as the VIA mini-ITX boards as well as low power Pentium-M OR Celeron-M. Please note that powering full power P4 or AMD systems is not recommended due to excessive heat dissipation. If using processors with TPD of 40 watts or more, please use two 40mm fans for increased air circulation. 2.
PAGE 3
.0 VoomPC installation steps 1) Install the motherboard on the base plate using four screws. (See figure 1.0) 2) Install the 2.5” hard drive (see area B). Place the 4 silicone rubber shock absorbent pads over the hard drive mounting holes. Fasten the hard drive using 4 undercut M3 screws attached from the bottom. (See figure 1.1) 3) Attach a 44-40 pin IDE cable to the hard drive and motherboard. 4) Attach the M1-ATX or M2 ATX power supply over the hard drive, using the remaining standoffs. (See figure 1.
PAGE 4
7) Connect the LED wire to the LED output of your M1-ATX / M2-ATX (consult PSU manual) for LED pins. 8) Connect the ON/OFF wire harness (provided in the PSU package) to the M1-ATX ON/OFF controller and to the ON/OFF motherboard switch. (consult your PSU manual). 9) (Optional) Connect the Amp enable wire harness to your Amp. Please pay special attention to the polarity of the wires. NOTE: Your Amplifier remote control unit actually needs only one wire (RMT), GND is optional.