Owner manual

Page Number - 2

Form 822678

Bleeding Anti-Lock Brake Systems

Always refer to the vehicle’s owner manual or the appropriate service manual for manufacturer’s brake

bleeding procedure. The front brakes on most anti-lock brake systems may be bled in the conventional

manner. Most hydraulic pump/pressure accumulator units are fitted with a bleeder valve, which must be

bled when the system has lost fluid or is being replaced. Some vehicles require that the system be

pressurized when the rear brakes are bled. Acura, Ford and General Motors require a bleeding

procedure, which uses specialized equipment.

Bench Bleeding System

Whenever a master cylinder has been removed from a vehicle or a new one is being installed, the

master cylinder must be bench bled. Failure to bench bleed is the main reason for unsuccessful master

cylinder replacement. Bench bleeding greatly decreases the chance that any air will be caught in the

cylinder upon reinstallation. Most manufacturers include a bench bleeding kit with new or remanufactured

master cylinders. If this kit was not included with the replacement part to be installed, consult with your

retailer prior to installing the new or rebuilt master cylinder on the vehicle.

* Consists of three adapters

Item Description Part No

2 Plastic Adapter 822597