Instructions / Assembly
Table Of Contents
- GENERAL
- INSTALLATION
- STEP 1. Feed the cord through the screw collar, canopy, nipple, and mounting plate-until you desired hanging height is met.
- STEP 2. Tie an overhand knot to secure wire in place above the nipple, and trim off excess wire to min 6” beyond the knot. Strip each wire end 5/8”
- STEP 3. Attach the mounting plate to the outlet box using the mounting screws.
- STEP 4. Fasten bare ground wire to ground wire from the wall outlet box (usually green or copper color) or connect ground wire to green screw on the mounting plate.
- STEP 5. Connect the neutral (white) fixture wire coming from the fixture base to neutral (usually white) outlet wire. Fasten both wires together with a plastic wire nut and tightly wrap the wire nut with electrical tape.
- STEP 6. Repeat the previous step with the hot (black wires). Make sure there are no exposed wires or strands that could cause a dangerous short circuit.
- FAILURE TO CONNECT THE APPROPRIATE WIRES CORRECTLY COULD RESULT IN SEROIUS INJURY OR DEATH!
- STEP 7. Carefully place wires into Outlet Box.
- STEP 8. Place the canopy with the fixture over the outlet box and fasten it by the screw collar.
- STEP 9. Install the lamp. The fixture is rated for 60-watt T lamp.
- DO NOT EXCEED RECOMMENDED WATTAGE!
- STEP 10. Attach the glass shade onto the fixture, secured it with the set screw.
- STEP 11. Restore power to the circuit at breaker or fuse-box.
- DIMMING
- CLEANING
- ASSEMBLYANDMOUNTINGDIAGRAM
- WIRE NUT/TAPINGDIAGRAM