Installation Guide

Document Version: 11 11 | P a g e
© 2016 MiX Telematics International (Pty) Ltd.
6 Installation
6.1 Installation Steps
Step
Action
Software Tools
1)
Ensure the SIM is correctly prepared (refer to section 5.1).
None
2)
Insert the SIM card (refer to ESD precautions in section 4.4).
The SIM card orientation is illustrated in section 5.2
None
3)
Configure the unit.
MiX Fleet Manager
4)
Configure Bluetooth if applicable.
MiX TechTool
5)
Install the harness. (Section 6.5)
None
6)
Install the code plug socket. (Section 9)
None
7)
Install the GPS antenna. (Section 6.5.6 and 6.5.7)
None
8)
Connect power and signal inputs. (Section 10 and Section 11)
None
9)
Test the installation. (Section 16)
Verify that the unit reports
to the backend.
10)
Test GSM observing the LED flashing sequence (see 15.2.2)
None
11)
Test GPS observing the LED flashing sequence (see 15.2.1)
None
12)
Install unit. (Section 7)
On the MiX 4000, the unit maintains an on-board odometer. This starts at 0 km from the factory. An offset can
be sent from the MiX Telematics Fleet Manager user interface to align the odometer value on the MiX 4000
unit with the vehicle odometer at installation time using “MiX TechTool”. An updated value can be sent at any
time, over the air, from MiX Fleet Manager to realign these two values.
6.2 Installation Precautions
Should it be necessary to remove seats, covers or other components, care should be taken to avoid accidental
damage and/or disconnection of cables.
 All components should be checked for damage prior to being installed into the vehicle.
 A drill should be used for small installation openings.
 For larger openings, a conical milling cutter, compass saw or file should be used.
 All rough edges should be trimmed.
 Careful attention must be paid to the manufacturers’ safety regulations for all tools used.
 Oils and fuels must be collected in appropriate containers and disposed of in accordance with the law.
6.3 Positioning of product components
Installers should ensure that the components of the product do not influence or hamper the functioning of the
vehicle’s systems.
 Care should be taken to ensure that the product’s components are not damaged during installation.
 Ensure that sufficient space is available for all components of the product, prior to commencing the
installation.