Installation Guide

Document Version: 11 20 | P a g e

9 Code Plug Socket Installation

Note: Please follow the instructions, regarding the positioning of product components, as contained in the

“Safety” section (section 4) of this document.

 The Code Plug Socket must be installed inside the passenger compartment or the driver cabin, to protect

it from possible damage by water or other environmental factors.

 The Code Plug Socket should not be installed in or near the ventilation or heating systems, which may

cause damage to it due to overheating.

 The Code Plug Socket should be installed in a position where it will not be subjected to pressure, impact

or excessive vibration.

 Select the installation position carefully before proceeding with the installation.

 Mark and drill or cut the required hole. Hole size = 13/16” or 20 mm

 Remove the mounting clip from the socket.

 Remove the protection film from the adhesive surface of the foam ring and press it firmly against the back

of the interface.

 Insert the socket into the mounting hole and slide the mounting clip into position.