Installation Guide

Document Version: 11 35 | P a g e

Ignition input

The ignition input is used only to monitor the vehicle’s ignition line state, and

can measure up to 38V (37.95V). Disconnection of this wire can be detected

with open-wire detect.

21 Peripheral Power Manager

The MiX 4000 is equipped with outputs to power additional peripherals. When making use of the positive

drive outputs, adjust the peripheral power management settings within the unit configuration to avoid

excessive current draw from the peripherals when ignition is off.

Below are examples of standard and strict settings:

STANDARD POWER MANAGEMENT

STRICT POWER MANAGEMENT

NB! Do not use the power outputs when connecting critical or emergency type of inputs i.e. Panic or Tamper

Switch – these type of inputs will require a permanent power source in the event of emergency that the

events do in fact record.