Installation Guide

Document Version: 11 9 | P a g e

If an unsecured SIM is required:

 Ensure that the SIM is configured as “PIN not required”.

 The MiX 4000 will leave the SIM with this configuration.

 This SIM can be moved to a different device without risk of the PUK begin locked.

5.2 Inserting the SIM card

In order to insert the SIM card, the following steps must be followed:

 Observe ESD precautions as prescribed in section 4.4.

 The SIM card is accessible from the back panel.

 Insert the SIM card as indicated by the symbol on the label on the housing plastic. See the

diagrams below.

5.2.1 Open and close the unit

1. Lift the four clips on the back and front of the unit as illustrated in Figure 1 below.

2. Unhook and lift the cover as illustrated in Figure 2.

3. Make sure the SIM card is positioned correctly as indicated in Figure 3.

4. Insert SIM card as indicated in Figure 4.

5. Clip the cover back on; ensure the clips are secured as shown in Figure 5.

Figure 1: Opening of side clips

Figure 2: Unhook the cover