Instruction Manual

CHRONOGRAPH FUNCTION: CENTER SECOND HAND CHRONOGRAPH 1/1 sec.

Timing up to 59 minutes 59 seconds

A) DISPLAYS AND BUTTONS

B) SETTING THE TIME

C) SETTING THE DATE

D) USING THE CHRONOGRAPH

E) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY)

A) DISPLAYS AND BUTTONS

B) SETTING THE TIME

1. Pull the crown out to the 2nd position.

2. Turn the crown to set hour and minute hands.

3. When the crown is pushed back to the normal position, small second hand begins to run.

Cal. 0S20 Instruction manual

Chronograph

Hour hand

Chronograp

minute hand

Button

24 hour

1st position

2nd position

Nomal crown

Calenda

Button

Small Second

1/3

PAGE 1
Cal. 0S20 Instruction manual CHRONOGRAPH FUNCTION: CENTER SECOND HAND CHRONOGRAPH 1/1 sec. Timing up to 59 minutes 59 seconds A) DISPLAYS AND BUTTONS B) SETTING THE TIME C) SETTING THE DATE D) USING THE CHRONOGRAPH E) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY) A) DISPLAYS AND BUTTONS minute hand Chronograph Button Hour hand 24 hour 1st position Chronograp 2nd position Nomal crown Button Small Second Calenda B) SETTING THE TIME 1. Pull the crown out to the 2nd position. 2.
PAGE 2
C) SETTING THE DATE 1. Pull the crown out to the 1st position. 2. Turn the crown counter-clockwise to set the date. *If the date is set between the hours of around 9:00 PM and 1:00 AM, the date may not change on the following day. crown back to the normal position. 3. After the date has been set, push the crown back to the normal position. D) USING THE CHRONOGRAPH This chronograph is able to measure and display time in 1/1 second united up to maxinum of 59 minutes 59 seconds.
PAGE 3
E) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY) This procedure shoud be performed when the chronograph second hand does not return to zero position after the chronograph has been reset, and including after the battery has been replaced. 1. Pull the crown out to the 2nd position. 2. Press button "A" to set the chronograph second hand to the zero position. The chronograph hand can be advanced rapidly by continuously pressing button "A". 3.