T10 / T11
T10 T11 500 235 490 438 180 14:1 90 7.4V1100mAh 2.5 The wire that fixed on the landing gear is the receiver of the helicopter, disassembling this wire may be dangerous or causes accident. When the controller/helicopter is underpowered, the control distance would be shortened due to this effect. If the helicopter is underpowered, it would result in difficulty of taking off or lower flight altitude. If the helicopter is damaged or become deformed, please repair it intime. If it is seriously damaged (e.
Light indicator Power socket OFF split charging device ON Battery connecting plug Battery charging plug all-in-one charging device To meet the different demands from different customers worldwide, two different charging devices have been designed for charging. One is split charging device (1 piece charger +1 piece charge controller), the other one is all-in-one charging device (one charger only)The product is included with either of the two charging devices.
How to charge the helicopter by split charging device (Pic 3 & 4) � Turn off the helicopter; unplug the battery cable from the helicopter. � Insert the plug of the battery cable into the quadrate port of the charge controller (matching the plug to the port) Insert the plug of the charger cable into the circular port of the charge controller, then, connect the plug of the charger to AC power outlet to start charging. Once charging is proceeding, the red power light of the charge controller is on.
OFF ON ON OFF FF NO OFF ON NO FF OFF ON O O
ON OFF OFF ON the trimmer
PREPARATION FOR FLIGHT Must set the remote controller to the “OFF” position before operating step 1 1. Turn on the helicopter by inserting the battery plug into the battery socket, the helicopter light will keep quickly blinking for about 3 seconds while the helicopter is checking the middle point of the gyro. Then, the light of the helicopter will blink slowly, indicating that the helicopter is ready to connect with the remote controller. 2.