Operation Manual

Video function and videography device
TF memory card card reader
Videography device
If installed the C4002 videography device(should be ordered separately from MJX), the helicopter has
the videography function.
1. Turn on the helicopter by push the power switch. At this time, the red light and the green light
keep flashing in turn. Two seconds later, the green light keeps “ON” means it is ready.
2. When the helicopter is finished signal connection and is not under shooting condition, the
indicator light of the videography module keeps constant “ON”. At this time,
Turn the switch button on videography module to the direction of the videography icon (Pic. 13),
and then turn on the camera switch of the remote control, it will start taking videography and
the red light of module keeps flashing. Press the camera button again, videography taking
will be stopped.
Turn the switch button on videography module to the direction of the photography icon (Pic. 14),
and then press the camera button on the remote control to take photos.
Pic9 Pic11
Pic13 Pic14
Insert the TF memory card into the videography module.(Pic9)
Fix the videography module onto the bottom of the helicopter by
screws.(Pic10)
Open the helicopter nose and insert the plug of the videography module
into the video control socket, then, reinstall the helicopter nose.(Pic11)
How to install the videography device
Pic10
videography module