Product specifications

14
PX-3
Revision 01/04, Effective Date January 23, 2004
15
PX-3
Revision 01/04, Effective Date January 23, 2004
SETUP, ADJUSTMENT & OPERATION
ADJUSTMENT & OPERATION
Chop Cutting:
A chop cut is performed by cutting completely through an object in one pass. The following section describes the
correct procedure for performing a chop cut.
1. Position the Back Stop for a cross cut or rip cut.
2. Position the work against back stop.
3. Depress the Trigger Switch to start. Lower the Cutting Head to begin cutting.
4. Continue lowering the Cutting Head until the cut is complete.
5. When cutting is complete, raise the Cutting Head and release the Trigger Switch.
Position work against back
stop and perform the Cut
Back Stop in Forward
position for Cross Cut
Position Back Stop in
Backward Location
and thighten both the
knob and wing nut
CAUTION
!
Allow the Blade to stop moving before removing work
6. Remove work from the cutting area.
Loose wingnut located
underneath the table
Loose knob
Position work against back
stop as shown
and perform the cut
Rip Cutting:
Cross Cutting: