Product specifications

16
PX-3
Revision 01/04, Effective Date January 23, 2004
17
PX-3
Revision 01/04, Effective Date January 23, 2004
SETUP, ADJUSTMENT & OPERATION
Angle Cutting:
Angle cuts are performed using the chop cut method. For angle cuts the Adjustable Back Stop is removed and
repositioned. The following section describes the correct procedure for performing an angle cut.
1. Remove and position the Adjustable Back Stop.
2. Position the Back Stop for an angle cut.
3. Position the work below the Cutting Head.
4. Depress the Trigger Switch to start. Lower the Cutting Head to begin cutting.
5. Continue lowering the Cutting Head until the cut is complete.
6. When cutting is complete, raise the Cutting Head and release the Trigger Switch.
(B)
Pivot the back stop to the
desired angle
(A)
Loose the knob
(C)
Now the back stop is ready
CAUTION
!
Allow the Blade to stop moving before removing work
7. Remove work from the cutting area.
(D)
Place work against the back
stop and perform the cut