Manual

27
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
(A)
Place the 90º Protractor on
the Ruler/Stop.
(B)
Set the desired angle and
tighten the thumbscrew.
(C)
Position the 90º Protractor
and tighten the
retaining thumbscrew.
(D)
Position the tile against the 90º
Protractor and the Ruler/Stop.
Turn the motor ON.
(E)
Verify proper cooling ow on
both sides of the blade (See
Maintenance Section to
increase/decrease ow).
(F)
Perform the cut. Turn the motor
OFF when work is complete.
CAUTION

MK-101-24 OPERATION
To cut angles other than 45º angles or Miters, a 90º Protractor (MK Diamond Part No.
134569-MK) should be used.
NOTE: