User Manual

25
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
(A)
Remove the Adjustable
Cutting Guide.
(B)
Position the Dual 45º Flat Angle
Guide and tighten the
retaining thumbscrew.
(C)
Position the tile against the
Guide and Ruler/Stop. Turn the
motor on.
(D)
Verify proper cooling ow on
both sides of the blade (See
Maintenance Section to
increase/decrease ow).
(E)
Perform the cut. Turn the motor
OFF when work is complete.
CAUTION
MK-101-24 OPERATION

To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134577-MK)
should be used.
NOTE: