Manual

MK-101 Type Blade Alignment Revision 12/00, Effective Date: December 04, 2000 Page-1

MK-101 TYPE BLADE ALIGNMENT PROCEDURE

The Movable Cutting Table of the MK-101 may become misaligned with the Cutting Head of the Tile Saw over

time. Should misalignment occur, perform the following steps to realign the Tile Saw.

NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if alignment

is off by more than 1/8-inch, contact the MK Diamond Service Center – (800) 474-5594

Tools Needed:

Preparation:

1/2-inch Wrench or

MK Triple Hole Box Wrench

and MK Open End Wrench

Combination Square (Square)

12-inch or Greater

(A)

Remove Tile Saw

from Power Source

(C)

Inspect Tile Saw

for damage

(D)

Inspect Diamond Blade

for damage

(B)

Remove Water Pan

(E)

Loosen front and rear

Guide Bar Retaining Bolts

Disconnect Saw

Remove Pan

Inspect

Blade

Inspect Cutting HeadInspect Frame

Turn Counter-

clockwise

to Loosen

Inspect Cutting Table

PAGE 1
MK-101 TYPE BLADE ALIGNMENT PROCEDURE The Movable Cutting Table of the MK-101 may become misaligned with the Cutting Head of the Tile Saw over time. Should misalignment occur, perform the following steps to realign the Tile Saw.
PAGE 2
MK-101 TYPE BLADE ALIGNMENT PROCEDURE Horizontal Rough Alignment: The Horizontal alignment will ensure that straight cuts (or Rip Cuts) are made.
PAGE 3
MK-101 TYPE BLADE ALIGNMENT PROCEDURE 90º Alignment Verification: 90º-alignment verification ensures the blade cuts tile straight up and down and not at an angle. NOTES: If the blade is misaligned following 90º-alignment verification, return the saw to MK Diamond for repair. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.