Owner manual

23
(A)
Remove the Adjustable
Cutting Guide.
(B)
Position the Dual 45º Flat Angle
Guide and tighten the
retaining thumbscrew.
(D)
Verify proper cooling ow on
both sides of the blade (See
Maintenance Section to
increase/decrease ow).
(E)
Perform the cut. Turn the motor
OFF when work is complete.
CAUTION
(C)
Place tile on the Cutting Table.
MK-101 Pro24 ADJUSTMENT
DIAGONAL CUTTING
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed.
NOTE: To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No. 134577-MK)
should be used.