Owner manual

(A)

Place the 90º Protractor on

the Ruler/Stop.

(B)

Set the desired angle and

tighten the thumbscrew.

(C)

Position the 90º Protractor

and tighten the

retaining thumbscrew.

(D)

Position the tile against the 90º

Protractor and the Ruler/Stop.

Turn the motor ON.

(E)

Verify proper cooling ow on

both sides of the blade (See

Maintenance Section to

increase/decrease ow).

(F)

Perform the cut. Turn the motor

OFF when work is complete.

CAUTION

MK-101 Pro24 ADJUSTMENT

OFF-ANGLE CUTTING

NOTE: To cut 45º Miters, the 45º Bullnose Miter Guide (MK Diamond Part No. 153201-MK) should

be used.

DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for

which it was designed.