User guide

21
MK-1280 GAS SAW OPERATION
Skip step C, if cutting dry.
CUTTING
NOTE:
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which
it was designed.
CAUTION
Fig. A
Set the Adjustable Cutting
Guide
Fig. B
Position the masonry piece
Fig. G
Move the Throttle Lever to
lower blade speed. Refer to
yourspecicenginemanual
Fig. H
Turn the engine OFF when
work is complete
Fig. D
Start saw. Move the Throttle
Lever to start saw adjust blade
speed (faster blade speed for
smoother cuts) Refer to your
specicenginemanual
Fig. F
Slowly push piece toward the
blade – continue until the
cut is complete
Fig. E
Setup to Cut
Fig. C
Open the Cooling Flow Control
Valveandadjustow.Verifycooling
owexistsonbothsidesoftheblade