Instruction Manual

MK Diamond Products Inc. Customer Service Department [phone]
MK-145 Revision 09/04, Effective date – September 23, 2004 Page
21
SETUP
,
ADJUSTMENT and OPERATION:
STEP ACTION
DO NOT FORCE TOOL, it will do the job better and safer at the rate for
which it was designed.
8. Cutting Tile
a) Feed the tile into the Diamond Blade with a
steady even pressure (forcing the tile will cause
the blade to slow which could cause motor
overheating)
9. Cutting Complete
a) Turn saw off when cutting is complete
Off Position
Feed Tile Slowly