Instruction Manual

19
MK-SCARIFIER ASSEMBLY
The Height Adjustment Hand-wheel will adjust the depth (up or down) of the Cutting Drum
by 1/16 of an inch per turn.
A) Congure the Cutting Drum for Grooving
B) Locate the lowest spot and highest spot on the surface
C) Adjust the height of the Cutting Drum to remove approximately 1/16 of an inch from the
high spot
D) Set the Vibration Lock
E) Move the Scarier in a smooth forward motion.
F) When the Cutting Discs are no longer contacting the surface, return the Scarier to the
starting position
G) Repeat Steps A through E until the Surface is level (See Figure 1)
A) Congure the Cutting Drum for Grooving
B) Adjust the Cutting Drum Depth until the Scarier is cutting grooves approximately 1/8 of
an inch
C) Move the Scarier in a smooth forward motion
D) Should the Cutting Discs loose contact with the surface, repeat Step B and continue
forward motion
E) Repeat Steps A through D until the desired number of grooves are cut (See Figure 2)
NOTE:
Leveling a Surface
Cutting/Grooving a Surface
Direction of Movement
Set 1/16 –
inch below
the surface
High Point
Figure 1
Figure 2
Set 1/8 – inch
below the
surface
Maintain
set cutting
depth
Direction of Movement