Setup guide
page 12
The best way to avoid speaker damage is to use common sense. Use moderate boosts of tone controls
or equalizers, at the very most. Listen carefully for any harshness and break-up, especially at high volume
levels, and turn down the volume when needed. If you cannot get enough volume, you may need to consider
a higher-powered amplier. If you have any questions about this, please contact MK, and we will be happy to
discuss it with you.
10. MK 5.1 MULTI-CHANNEL & PRO-LOGIC SYSTEM SETUP GUIDE
The 5 Most Important Items In System Setup:
1. Find the best location for the subwoofer for maximum output and attest response
(usually the corner closest to the listening position)
2. Aim the front speakers (and the surrounds, if possible) for the attest response and
the best imaging
3. Set all speakers to the Small setting for proper High-Pass and Low-Pass Filter
operation to get the lowest distortion and maximum dynamic range
4. Calibrate all speakers and the subwoofer to the identical level for proper imaging
and balance
5. Make sure all speakers are in phase for proper imaging and impact
These instructions will help you make sure that you cover all steps in setting up a 5.1 multi-channel or Pro
Logic surround sound system. In addition to following this list, make certain that you study and understand
the owner’s manual for each and every component used in the system, especially the processor/receiver’s
manual. Have fun and good luck!
A useful tool for system setup is the DVD called Video Essentials. If you don’t have one, you can order it by
visiting the web site at www.videoessentials.com.
Here are instructions for your speaker setup.
Locate the front speakers 1.
The left, right, and center speakers should be equidistant from the main listening position. Try to set up the
speakers so that they are reasonably symmetrical to room surfaces. A tape measure may be very helpful.
2. Locate the subwoofer
One of the best places for the subwoofer is the corner with the best structural strength. If the corners are
roughly equal in construction, use the corner nearest the listening position. If the listening position is in the
front half of the room, place the subwoofer in a front corner. If it is in the back of the room, place the subwoofer
in a back corner. If possible, avoid corners near doorways or openings.
If you are willing to experiment, another option is to place the subwoofer at the listening position and walk
around the room. Stand in and near each corner. The location where you hear the tightest bass with the most
impact is probably the best location in the room for the subwoofer. If multiple subwoofers are used, place them
in the same location. Stacking is best, but you can also put them side by side.
Another option for multiple subwoofers is to place them in different locations. This is appropriate when you
have limited choices in locating the subwoofer and none of the available locations work well. Try to place
multiple subwoofers at equal distances from the listening position to avoid phase cancellation.