Instruction manual

PRODUCT DESCRIPTION
14 Z216MK_V4.14 © Hermle Labortechnik GmbH
1.8.6 Song selection for sound signal - end of run (optional)
Proceed as described under point 1.8.2 to enter this program mode and then press the key
„accel/decel“ (5). In the display „accel/decel“ (A-2) flashes the word „service“. Now select the letter
„G“. with the adjusting knob (1). As a result appears in the display „rpm/rcf“ (A-1) the word „
SonGo/Sound“. After pressing the key „rpm/rcf“ (4), you can select a song with the adjusting knob
(1). (see figure 8).
After you have stored the settings (see 1.8.2) you changed to the normal program mode again by
switch off the centrifuge for a short while.
Figure 8
1.8.7 Keyboard sound turn on / off (optional)
Proceed as described under point 1.8.2 to enter this program mode and then press the key
„accel/decel“ (5). In the display „accel/decel“ (A-2) flashes the word „service“. Now select the letter
„b“. with the adjusting knob (1). As a result appears in the display „rpm/rcf“ (A-1) the word
„ON/BEEP“. After pressing the key „rpm/rcf“ (4), you can turn the keyboard sound (On) or (Off) with
the adjusting knob (1). (see figure 9).
After you have stored the settings (see 1.8.2) you changed to the normal program mode again by
switch off the centrifuge for a short while.
Figure 9