Instruction manual

OPERATION
16 Z216MK_V4.14 © Hermle Labortechnik GmbH
2. OPERATION
2.1 Mounting and loading angle rotor
2.1.1 Installation of rotors
Clean the drive shaft as well as the rotor fixing with a clean, grease-free piece of cloth. Place the
rotor onto the drive shaft. (see figure 11) Take care that the rotor is fully installed onto the motor
shaft.
Figure 11
Hold the rotor with one hand and secure the rotor to the shaft by turning the fixing nut clockwise.
Tighten fixing nut with enclosed allen key (see figure 12)
Figure 13
ATTENTION: For safety always ensure that rotor fixing screw is tightened before each
run!! (see figure 12)
Figure 12