Instruction manual

OPERATION

2.5 Program

2.5.1 Storage of programs

You can store up to 99 runs with all relevant parameters, incl. the used rotors. You can use any free

program number and call it up again.

Put the needed rotor into the centrifuge. By pressing the key „prog“ (11) in the display „time“ (A-3)

appears the word „program“. With the adjusting knob (1) you can chose the desired program

number.

If a program number is already occupied in the display „rpm/rcf“ (A-1) will appear the words „rotor”

(M3) and „22x.xx“ (M4). In case of free program numbers it appears 0.

Figure 25

Close the lid of the centrifuge. Now proceed as already described to set all important run

parameters. If the lid isn't closed when storing the program, in the display „rpm/rcf" (A-1) flashes

alternately the word „FirSt" and „CLOSE Lid" (see figure 26). ). If you want to start the run without

storing the programm, in the display "rpm/rcf" (A-1) flashes alternately the word ""First" and "PrESS

StoreE" (see figure 27).

Abbildung 26 Abbildung 27

For adaption of data press the key „store“ (12) for approx. 1 second. If the program is store correctly,

the word StorE appears in the display „rpm/rcf" (A-1). As a result the word „program“ (M10)

disappears. As soon as the key „store“ (12) is no longer anymore, it reappears the word „programm

xx“ (M10) – the (xx) stands for the chosen program place.

If all program numbers are occupied you can take an old number that is not necessary anymore and

just put in the new parameters.

All with number marked passages refer to figure 26 and 27.