Instruction manual

OPERATION

Figure 29

2.6.2 The "STOP" key

By the „stop“ key (10) (see figure 30) you can interrupt the run at any time. After pressing the key the

centrifuge decelerates with the respective pre-selected intensity down to stand still.

Figure 30

2.7 Imbalance detection

In case of the rotor not being equally loaded, the drive will turn off during acceleration. The rotor

decelerates to stand still.

When in the display “time” (A-3) the word “error” (M11) together with the number “01” appear, the

weight difference of the samples is too huge. Weigh out the samples exactly!

Load the rotor as described in chapter 2.1.2 and 2.1.3.

When inside the display “time” (A-3) the word “error” together with the number “02“ (see figure 31)

appear, there could be following reasons: The imbalance switch is defective.

Figure 31