User manual

Page 4 • User Manual • Introduction & Important Notes
1. BMC MK III Introduction
Blue Sky is a philosophy. We design each product to represent the highest
ratio possible of performance to cost, providing the highest value added to
our customers.
We will continually seek out opportunities to utilize the talent of the Blue
Sky team to realize this philosophy. Our customer’s value requirements
will always be our prime focus, and only those products that achieve our
performance value ratio will earn the right to carry the Blue Sky logo.
The Blue Sky BMC MK III continues this lineage and philosophy of high value
and superior performance products. Designed for use with 5.1 channel
monitoring systems (and beyond!), the Blue Sky BMC MK III allows for
complete control of all monitoring system parameters from a single, easy-
to-use, remote control.
The Blue Sky BMC MK III eliminates the many variables of putting together
a reliable, easy to calibrate 5.1 monitoring system, allowing the user to
monitor with confidence!
We thank you for your investment in this Blue Sky product.
www.abluesky.com
3. The BMC MK III, what
is included?
The Blue Sky BMC MK III includes the items listed below. Please carefully
unpack each item and inspect the components for damage. If any item has
been damaged, please contact the dealer that supplied the product or Blue
Sky directly.
BMC MK III Inventory:
1 BMC MK III I/O Unit
1 BMC MK III Remote
1 25 Foot, 6 conductor, RJ-11 Cable
1 Owner’s Manual
1 Warranty Card
2. Important notes about this
manual.
The Owner’s Manual:
This manual addresses setup and operation of the Blue Sky BMC MK III.
This product includes several performance and operational changes, when
compared to the original Blue Sky BMC and BMC MK II. We ask that you
read this owner’s manual carefully, heed all warnings and contact Blue Sky
International if you have any comments or questions. Contact information
can be found on page 19 or you can visit:
www.abluesky.com.
Using the Blue Sky BMC MK III with the SAT 5 (all versions)
In order to get the proper summation between SAT 5 and a Blue Sky
subwoofer, when using the Blue Sky BMC MK III, it is important that you
switch the internal High Pass (HP) Filter on the back of the SAT 5 to the “OUT”
of circuit position. Because the BMC MK III already includes an internal High
Pass Filter, leaving the internal HP filter on the SAT 5 “IN” circuit, will create
a hole at the crossover point between the SAT and SUB,
USER MANUAL • 1 - 3 • INTRODUCTION & IMPORTANT NOTES
BMC MK III