Setup guide

2. You can also connect your satellite speakers to the subwoofer. If you choose to do this, connect the
amplifier to the "From Amplifier" terminals on the back of the subwoofer and connect the satellite speakers
to the "To Speakers" terminals on the back of the subwoofer. For each channel, make sure that the Positive
(+) terminal on the amplifier is connected to the Positive (+) "From Amplifier" terminal (and the Negative
(-) terminals are connected), and that the Positive (+) "To Speakers" terminal is connected to the Positive
(+) terminal on the speaker (the Negative (-) terminals should also be connected.
If your amplifier has two sets of speaker outputs (e.g., A and B), you can connect the satellites to one set and the
subwoofer to the other. But if you get weak or no output when you connect your speaker this way, connect both sets of
speaker wires to the same output terminals.
PLUGGING IN THE SUBWOOFER
Once all the speaker wires or preamp interconnect cables are in place, you are ready to plug in the subwoofer. Set
the "BASS LEVEL" control to "MIN". Attach the power cord to the receptacle on the subwoofer’s back panel. Then plug
the cord into the AC outlet.
Slide the power switch to either the “AUTO” or “ON” position. If you hear a “thump” from the subwoofer, this is the
normal sound of its power supply charging.
“AUTO” SWITCH POSITION
In the “AUTO” switch position, the subwoofer is in an idle condition when your system is turned off and no signal is
being fed to the subwoofer. When the subwoofer receives a signal from your receiver or processor, it automatically
switches on.
“ON” SWITCH POSITION
In the “ON” switch position, the subwoofer is fully active, whether or not your other components are turned on.
Do not plug the subwoofer into a switched outlet on another component.
POWERED SUBWOOFER
BASS LEVELLOW PASS FILTER
AUTO
OFF
ON
+
-
FROM AMP
TO SPEAKERS
LEFT
RIGHT
LEFT
RIGHT
MAX
MIN
230V
115V
VO LTAGE
BYPASS
40Hz
120Hz
80Hz
60Hz
100Hz
200Hz
140 Hz
REFERENCE LEVEL
+
+
AMPLIFIER OR RECEIVER
+
+
RIGHT
LEFT
SATELLITE SPEAKERS
8
FIGURE 4 - SATELLITE SPEAKER WIRING (OPTIONAL)