Owner's manual

VALVAL--uu LineLine®® Series Series –– Printer Driven 24V DrawersPrinter Driven 24V Drawers

Quick Installation InstructionsQuick Installation Instructions

Placement of Cash Drawer

• Prepare a location for the cash drawer by selecting a secured, leveled

Troubleshooting:

Cash Drawer does not open electronically

• MMF Cash Drawer’s Printer-Driven Interface connects directly to a

receipt printer. This connection requires the POS application to send

the proper opening codes to the printer, which will then send the

signal to open the Cash Drawer. Consult the documentation or manuals

for your particular printer for the proper open codes.

Applicable Part Numbers:

•2251516442-XX

•22613316C212-XX

•22613313C212-XX

XX denotes Color: (04) Black / (89) Putty / (G3) Stainless Steel

For parts and/or additional accessories, contact your supplier or visit our website at http://www.mmfpos.com

VAL-u Line Inst. Sheet (08-23-2012)

WHEELING, IL

• Prepare a location for the cash drawer by selecting a secured, leveled

surface that is no smaller than the cash drawer.

• Position the cash drawer and remove any packing tape or guards from

the tray.

Connection:

The printer-driven Interface has been designed to be used with a variety of

POS printers by connecting printer specific cables.

• Connect one side of the corresponding printer-specific MMF RJ-12 Cable

to the interface connection located behind the cash drawer. The end of the

cable that has a label with the MMF cable part number will plug into the

Cash Drawer and the end that has a label that reads: “Connect to

Printer” should plug into the receipt printer.

• Follow the set-up instructions and set proper open codes from the printer

manufacturer manual to properly connect the cash drawer to the receipt

printer.

• Verify the correct end of the RJ-12 printer cable is connected to the

cash drawer as well as the printer.

• Verify correct position of the lock. If using a three position lock, the

lock would need to be in the 12 o’clock position to open electronically.

• Verify Baud Rate, Parity, Data Bits, and Stop Bits are set correctly for

your software. Baud Rate should be set between 110-9600.

Warnings/Safety Instructions:

• Avoid breaking coin rolls on the drawer front or the currency

tray.

• Lubricate the slides and latch mechanism periodically. Do not

clean roller bearings or slides with any water or substance

cleaners; use a lint-free fabric to wipe old grease and/or debris.