Instructions / Assembly

Page 3 of 5
• Elastomeric or Polyurethane Caulk (To ensure that the door unit is properly caulked
and all fastener holes are filled.)
Step #1
Ensure the door unit is properly caulked per installation instructions. If necessary, set
and fill all fastener holes. Ensure all caulking is fully cured before proceeding to the next
step.
Step #2
Remove or mask off all hardware prior to painting.
Step #3
Lightly scuff sand the door and jamb per above sanding instructions.
Step #4
Wipe the door with a clean cotton cloth.
Step #5
Apply a quality primer according to manufacturer’s instructions. Note: Make sure all six
sides - front, back, edges, top and bottom - receive the same uniform coverage.
Step #6
Apply 2 coats of a quality paint according to manufacturer’s instructions. For wood and
molded panel doors, always follow the grain of the door. Paint the panels first then
the stiles and rails. Allow the door to dry completely between coats Note: Make sure all
six sides - front, back, edges, top and bottom - receive the same uniform coverage.
Step #7
Allow the paint to dry completely before unmasking and installing hardware.
How to Stain an Interior Door
Supplies Required:
• High Quality Oil Based Pre-Stain Wood Conditioner
• High Quality Oil Based Stain* - Approx. 1 Quart