Installation Guide

Page 4 of 4
Double Door Installation
Step 9: Shim & Secure Inactive Hinge Jamb
a) Complete steps 1 and 2.
b) Add shims above the head jamb from the inside to maintain proper clearances and
alignment.
c) plumb and nail the brickmold from the outside on the inactive door side only.
Step 10: Shim & Secure Active Hinge Jamb
a) Do steps 3 c, d and e.
b) Nail the head in place at the shim locations.
c) Nail the head and hinge jamb brickmold.
d) Follow step 5 and 6.
Policy
a. All unfinished doors are subject to possible leakage around the glass, and around
panels, and/or around lock openings until such time as they are properly finished in
accordance with the manufacturer’s directions. Failure to comply will void any warranty
expressed or implied against such leakage and will not be considered a product failure.
b. Proper installation is essential to prevent water leakage under normal conditions.
Failure to properly caulk under and around any unit as per the installation instructions
can cause water leakage and/or frame rot. installation Not in accordance with the
manufacturer’s directions will void any warranty expressed or implied against such
leakage and will not be considered a product failure.
c. All residential products are designed to be used under normal conditions. Any
application which results in severe exposure should be considered a special
circumstance and appropriate precautions should be taken before determining what
product is best suited for a particular application. when in doubt, call for more
information before proceeding.
d. Manufacturer/Distributor reserve the right to refund the original purchase price or to
repair/replace at our option any product which it deems to have failed.
Manufacturer/Distributor will not be responsible for incidental or consequential
damage. Frame rot can be considered one form of incidental or consequential damage
resulting from water leakage, whether visible or not. Consumers are advised to report
any signs of leakage immediately to the installer or to the Dealer where said product
was purchased.
e. An overhang that minimizes the exposure to the elements is recommended. If that is
not possible, understand that frequent re-coating will be required to keep from
damaging the finish topcoat. Peeling can be a result of such exposure.
f. Door and frame must be finished within 30 days of installation. Failure to comply will
void any warranty expressed or implied against peeling and or warping.
See Warranty for details.