User's Manual

MONITOR OPERATION

Power ON/OFF

Use the volume and ON/OFF switch (g. 7) on the side of the unit to turn On

and O. To adjust the volume use the ON/OFF switch to scroll to the desired

level.

Channel Selecon

Press the Mode Buon on the front of the monitor 1 me to enter the channel

selector mode, use the side “+” and “-” control buons (see g. 2) to change

the Channel or to set your monitor to Scan mode. The display will indicate the

selected channel during the channel selecon process on the boom of the

screen.



Automac Channel Scan

This opon allows the Monitor to scan through all 4 channels automacally and

stops at each channel for approximately 5 seconds in order to monitor mulple

locaons.

“Scan Select Mode”- Selecng which camera to Scan

To set your monitor to scan certain channels while in scan mode, press the

Mode Buon 4 mes unl the Scan Select menu appears. Use the Mode buon

to scroll through the available channels and the “+” and “-” control buons (see

g. 2) to select and deselect the desired channel(s).

“Camera Selecon”- Add or Remove Cameras

To remove paired cameras, press the Mode buon 8 mes unl the Paired

Select menu appears. Use the Mode buon to scroll through the available chan-

nels and the “+” and “-” controls (see g. 2) to select or remove the camera.

Note: You must re-link your camera once it has been removed in order to be able to view

the camera again (see page 12 for linking instrucons).