User's Manual

RADIO INTERFERENCE ADVICE WARRANTY

FCC Statement

This device complies with part 15 of the FCC Rules. Operaon is subject to the

following two condions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference

that may cause undesired operaon.

Any changes or modicaons not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

FCC Radiaon Exposure Statement:

This equipment complies with FCC radiaon exposure limits set forth for un

controlled environment. This equipment should be installed and operated with

minimum distance 20cm between the radiator and your body. This transmier

must not be co-located or operang in conjuncon with any other antenna or

transmier. This equipment complies with FCC RF radiaon exposure limits set

IC STATEMENT:

Operaon of this device is subject to the following two condions:

1. this device may not cause interference, and

2. this device must accept any interference, including interference that

may cause undesired operaon of the device.

controlled environment.The model70055T should be installed and operated with

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

—Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

transmier.

Note: This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

radio frequency energy and, if not installed and used in accordance with the

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

the receiver is connected.