User's Manual
Table Of Contents
- 1 Introduction 1
- Basic Operations
- Client Applications
- Local Services
- Configuration Panel
- Security
- Technical Support
- Troubleshooting
- Cannot connect to a paired device:
- Cannot discover services on an un-paired remote device:
- Dial-up Networking service does not start:
- How do I determine the Bluetooth Device Address (BDA) of my hardware device?
- How do I determine the version number of the Bluetooth Specification that the Host Controller Interface (HCI) complies with?
- How do I determine the version number of the Link Manager Protocol (LMP)?
- How do I find information about the Bluetooth hardware attached to my computer?
- How do I test a Network Access connection?
- Why do I get an Unknown Port message when I attempt to use a Bluetooth Serial Port?
- Glossary
BTW Configuration & User’s Guide Configuration Panel
April 5, 2002 WIDCOMM
23
5.4 HARDWARE CONFIGURATION
The Hardware tab of the Bluetooth Configuration Panel provides basic information about
the Bluetooth hardware installed on this computer and access to the Advanced Settings
dialog box, if required:
• Devices:
! Name: the name of the device, e.g., WIDCOMM Bluetooth Device
! Type: the type of device, e.g., USB.
• Device Properties:
! Manufacturer: the name of the company that manufactured the device
selected in the Devices section of this dialog box.
! Firmware Revision: the manufacturer's firmware version number.
! Device status: indicates that the device is operating properly or that there is a
problem/conflict.
! Device Address: the Bluetooth Device Address (BDA or BD_Addr)
programmed into this device when it was manufactured.
! HCI Version: the version number of the Bluetooth Specification that the
Host Controller Interface complies with.
! HCI Revision: the revision number of the Bluetooth Specification that the
Host Controller Interface complies with.
! LMP Version: the version number of the Bluetooth Specification that the
Link Manager Protocol complies with.
! LMP Sub Version: the sub-version number of the Bluetooth Specification
that the Link Manager Protocol complies with.
• The Advanced button: displays the Advanced Settings dialog box, which allows
you to select the country code and transmission power settings. This option is not
available on all systems.