Users Manual

Preparing the cameras
19
English (United Kingdom)
Inserting/removing the micro SD card
Inserting a micro SD card
X
Remove the front camera from the
bracket; see page 18.
X
Insert the micro SD card in to micro SD
card slot (4) as illustrated until the micro
SD card engages.
! The micro SD card may first have to be
formatted before it can be used with the
dashcam. In such a case, the status LED
lights up red; see page 20.
Removing a micro SD card
!
After removing the front camera, wait
approximately 5 seconds so that the data
can be stored on the micro SD card.
X
Remove the front camera from the
bracket; see page 18.
X
Press the micro SD card.
The micro SD card is ejected.
X
Remove the micro SD card.
Aligning the camera
!
Make sure that you do not touch the
camera lens while aligning the camera.
A dirty lens can affect the image quality.
X
Authorise the end device and connect it
with the dashcam; see page 23.
X
Open the web app or the smartphone app;
see page 24.
X
Check the vertical alignment of the front
camera using the live preview in the app.
X
If required, correct the alignment of the
front camera.
X
If installed, also check the vertical
alignment of the rear camera using the live
preview in the app and adjust if necessary.
i Clean the camera lenses regularly with a
soft, lint-free cloth and make sure you
have a clean windscreen and rear
window. Check the alignment of the
cameras at regular intervals.
G DANGER
Micro SD cards are small parts. They can be
swallowed and cause asphyxiation. This
poses a risk of serious or even fatal injury.
Store micro SD cards where children cannot
reach them. If a micro SD card is swallowed,
seek medical attention immediately.
SD
4
M+P-03F-9724
M+P-03F-9725