User's Manual

312
page
Appendix
313
page
Appendix
IMPORTANT
Never attempt to open the unit besides when disposing of it.
For replacement of the built-in battery, contact your nearest Kenwood service agent.
note
• Remove the built-in battery after having confirmed that it is completely discharged.
• Once the built-in battery is disconnected, do not attempt to reconnect it to the connector on the circuit
board.
• Bring the removed built-in battery to a rechargeable battery recycling business as early as possible.
WARNING
• Do not heat excessively the built-in battery, open it, modify it or throw it in fire or water.
Excessive heat generation, explosion or fire ignition may cause a fire.
• Do not leave the built-in battery near fire or under direct sunlight.
A fire, explosion or excessive heat generation may result.
• Attach insulating tape on the connectors of the built-in battery.
A fire or explosion may result if the battery electrodes are short-circuited.
• Do not leave the built-in battery within the reach of children.
Injury or other accidents may result.
• If the built-in battery fluid leaks and enters your eyes, immediately rinse your eyes with fresh water and
call a doctor.
If the fluid is left in your eyes, an eye injury may result.
Recycling the Built-in Battery
The unit uses a lithium ion rechargeable battery cell as the built-in battery. The lithium ion rechargeable
battery is a recyclable resource. When disposing of the unit, take out the built-in battery and bring it to your
local recycling business.
Removing the Built-in Battery to Dispose
703
703
1 Remove four screws.
At this time, insert the fingernail etc. in the space between
the frame and the front panel to release fixed hooks that
exist in all surroundings.
2 Open half the front panel and remove the flexible cable from
the connector on the PCB.
3 Remove four screws.
At this time, insert the fingernail etc. in the space between
the frame and the rear panel to release fixed hooks that exist
in all surroundings.
4 Open the rear panel and remove two connectors on the
PCB.
5 Open half the PCB and remove the flexible cable from the
connector the PCB.
6 Open half the PCB and remove two connectors on the PCB.
7 Remove the built-in battery from the rear panel.