User's Manual

2 3
Introduction
The me-d200/d350 range is a 1 to 5 Watt radio data
modem, which can be used for data up to 9600 baud rate
(using GMSK module) in stand alone conditions.
The me-d200/d350 is housed in a rugged cast-aluminium
box sealed to IEC 529 (IP54) making it suitable for a wide
range of mobile and fi xed applications.
All me-d200 modem units meet the essential requirements
of the relevant European directives and all me-d350
modems meet relevant US FCC and Canadian regulations.
In order to maintain this compliance the installation and
safety information must be adhered to at all times.
The me-d200/d350 modem must only be installed where
unintentional contact cannot be made. The surface of
the device may be hot to touch under certain transmit
conditions. A warning label is permanently displayed as
part of the equipment rating label affi xed to the lid. The
me-d200/d350 is not designed for permanent transmis-
sion. If prolonged transmission periods are used, the
unit will become hot and will require an additional
heatsink to be fi tted.
When fi tting the me-d200/d350 into a fi xed installation,
care must be taken in the routing of all cabling such that
the insulation cannot become damaged.
The recommended supply sources for use with the me-
d200/d350 are a standard 12V supply, but is capable of
operating in the range
(9V - 18V).
●
●
●
Preparing for use
Unpacking and inspection
Unpack the modem and check that you have received the
following items:
me-d200 or d350 Transceiver
User Guide (this document)
me-d200 diagram
me-d350 diagram:
If any of these items are missing, please contact your
supplier.
●
●
e11 034663
35