1 2 3 4 IN THE BOX 1. StudioDeck™ Turntable 6. Power Cord 2. Dustcover 7. Counterweight 3. Delrin‰ Platter 8. Additional Parts • Hex Wrench (2) • Anti-skate Weight • Stylus Brush 4. Platter Belt 5.
ASSEMBLY Make sure StudioDeck™ is placed on a level surface If cartridge is not included, follow cartridge manufacturer’s installation instructions Carefully place the Delrin‰ platter on the bearing hub, making sure it spins freely. Install the turntable belt, with the belt attached to the top pulley for 33 RPM records, and the bottom pulley for 45 RPM records.
TRACKING FORCE AND ANTI-SKATE Install the supplied counterweight onto the tonearm’s endstub and balance the arm for zero-tracking. Using a stylus force gauge, rotate the counterweight until the desired tracking force is achieved per your cartridge manufacturer’s specifications. Attach the anti-skate weight with loop to the anti-skate pin, and dress the remaining line and weight to the arm’s anti-skate hanger. Set the loop to the suggested notch on the pin based on your cartridge’s weight.
VTA AND AZIMUTH If StudioDeck™ came with StudioTracker™ preinstalled, the following steps were completed at the factory Front Lines After setting tracking force and anti-skate, adjust the tonearm’s height. Loosen the hex screw located at the base of the tonearm to raise or lower the arm height, and tighten once the arm is parallel to the record surface. Next, adjust your headshell and cartridge for correct azimuth.
CONNECTIONS AND LEVELING Install the RCA interconnects and ground wire to your preamp’s phono section, and then connect the power cord from the turntable to any outlet or power conditioner of your choice. If the turntable is on an unleveled surface, place a bubble level on the platter, then carefully adjust each foot until the turntable’s platter is true.
Back to Front STYLUS CARE AND DUSTCOVER Keep your records clean by using a high-quality record brush and record cleaner After each play, gently clean your stylus, always brushing back-tofront using the supplied stylus brush. We also recommend using a liquid stylus cleaner such as Mobile Fidelity LP#9. When not in use, please cover your turntable with the supplied dustcover. For best sonic results, remove the dustcover while playing.
StudioDeck™ UltraDeck™ Motor 300 RPM AC Synchronous 300 RPM AC Synchronous Speeds 33 1/3 RPM, 45.0 RPM 33 1/3 RPM, 45.0 RPM Platter 3.88 lb Delrin‰ 6.8 lb Delrin‰ Wow & Flutter 0.017% – 0.025% 0.017% – 0.025% Signal-To-Noise Ratio 72dB 74dB Power Supply Requirements 120V 60Hz, 220-230V 50Hz, 100V 50Hz 120V 60Hz, 220-230V 50Hz, 100V 50Hz Power Consumption < 5W < 5W Dimensions 19.69" x 5.375" x 14.25" 19.69" x 6" x 14.25" Weight 19.1 lb 23.
www.mofielectronics.