Product Manual

1
PIN Pad For
Connect™
Power Supply
(400-00054)
2 3
Use
only provided AC/DC adapter model W&T-AD36W052300F
manufactured by W&T Electronics Co., Ltd., with output rating
5.2VDC @
3A, or model CDS015-T051, manufactured by Adapter
Technology Co., Ltd.
, with output rating 5.15VDC @ 3A.
PIN PAD FOR CONNECT™ PRODUCT MANUAL
2
MTI P/N 063-00318 rev A ©2019 MTI All Rights Reservedwww.mtigs.com | T:800.426.6844
INSTALLATION
MATERIALS IN BOX
Main Plug of the adapter acts as disconnect
device, the socket-outlet shall be installed near
the equipment and shall be easily accessible.
Warning: The Adapter used must be marked with "LPS"
or "Limited Power Sources"; any others are prohibited
for use.
La prise principale de l'adaptateur agit comme
un dispositif de deconnexion, la prise de courant
doit etre installee pres de l'equipement
et doit etre facilement accessible.
Avertissement: L'adaptateur utilise doit porter la
mention «LPS» ou «Sources d'alimentation limitees».
sinon, ces autres sont interdits d'utilisation.
If wall mounting, install two wood or drywall screws 5
inches apart into the wall 1m to 1.5m from the oor and
per local zoning, safety, and ADA regulations. Use wall
anchors if installing into drywall between studs. Hang
the PIN Pad on the screw heads using the slots (circled
below) in the back of the PIN Pad.
Alternately, the
PIN Pad can be
installed on a
standard 75mm
VESA mount
(noted in blue).
Plug the provided power supply into the barrel connector
on the bottom of the PIN Pad and plug the Power
Supply's power cable into the nearest outlet. Use
an outlet installed near the equipment that is easily
accessible.
Connect a Cat 5e (or better) Ethernet cable with Internet
connection to the RJ-45 connector on the side of the
PIN Pad.